Rock Hard 4X4 Shorty Front Bumper with Fog Lights & Rear Bumper for 07-18 Jeep Wrangler JK

Rockhard 4x4 Parts 2007 JK Front Shorty Bumper Is made from 1/4" plate to withstand Rockhard Abuse. Tapers down and back to protect the Factory Lower front cross frame and Sway-bar Disconnect unit (if equipped). Provides the best possible approch angle without cutting of the factory frame. Winch is mounted on top of the bumper so there is room for the factory Fog Lights down low. Lights are recessed to protect them from damage. D-rings are 5/8" x 2 1/2" with hole for 7/8" pin. Engine cooling has not been a problem as we ran the AC all the way in and out of the Rubicon Trail.

The Rock Hard Jeep JK Wrangler Rear Bumper/Tire-Carrier is the only JK rear bumper on the market today that is made out of 1/4" thick plate steel. Designed with tapered ends for increased departure angles, this bumper will hold up to a 38" tire, comes standard with an integrated Class 2 hitch receiver, CB antenna mount, a horizontal Hi-Lift Jack mount with padlock provision and two 5/8" x 2-1/2" CNC D-Ring shackle mount with tabs that are welded on front, go through bumper and then are welded on the backside as well. All necessary hardware necessary for the installation is provided and an optional Jerry Can Mounts and a Rock Rack are all available for purchase separately.
Shown with Tire Carrier.

Installation Notes

Installation Difficulty:

Level 3Advanced

1. Bumper without Tire Carrier is not Designed to accept the Tire Carrier at a later date.

Installation Time: 2-4 hours

Parts Included

Front Bumper
Rear Bumper
Tire Carrier (if applicable)