WARN 101337 Elite Series Full Width Front Bumper with Grille Guard for 18-25 Jeep Wrangler JL & Gladiator JT

Great Bumper! Didn't experience any to terribly difficult, I did have help using a 1 Ton portable Shop Crane,it is bulky but face it all winch bumpers are pretty cumbersome to handle by yourself. There is a little trimming of the Frame Rails if you install Warn's Zeon winch, this procedure is covered in the installation instructions,you lose two bolt holes but you gain support back. Instead of the 8 bolt pattern the holds on the factory bumper you have 10,it's a solid installation. Also factory fog lights need a tab trimmed,but supplied light mounts are more then adequate to attach them,also in the instructions.Installation time,including Winch, lighting and all wiring completed around 5 hours.

Installed this bumper yesterday, it took about 3 hours. Some issues we came across. If you are going to use the halogen lights from the original bumper you will need to cut into the bumper to remove them. You cannot get the wiring out because the bumper was molded around the tow hooks. Just used a saw. Also the bolts to attached to jeep are hard to get in the small area. We used tied twine around the bolt and fished it through. Worked pretty good. Other than that it was pretty clear. Just took us about 3 hours.

I love Warn products. Instructions could have been better. Photos as well, especially regarding the fitment of the fog lights. I had to trim the gussets on the inside of the bumper to get a Warn Zenon 10 winch to fit properly. Come on, Warn! Nonetheless, it is a very good looking bumper.