« Back to product
Dean P.
Can I have the Edelbrock E-force supercharger programmed to run on regular gas?
No. Sorry. Any failures associated with not using premium 91 octane gasoline or higher, will be ineligible for warranty repairs. Thanks for your inquiry.
Andrew M.
Should I have my jeep regeared before installing this supercharger. I still run factory wheels for commuting. Weekend the 33×12.50 m.t go on. But I will never go bigger than a 35" tire. Also, do you know any shops around Philadelphia area familiar with installing the eforce? I have the ability but no time, but I will do it if I have to!
If you are deciding to regear, It would be suggested to assess whether you need the gear ratio change after the installation of the Supercharger. D'Antonio Automotive in West Chester is our installer of choice in the region. D'Antonio Automotive Thanks for your inquiry.
Richard W.
I have a 2017 JKU with an unlocked PCM and a Flashpaq programmer, is this compatible with this supercharger?
No. During our testing we have found that once a Superchips Programmer has been installed the ECM (Engine Control Module) will not communicate with any other programmer such as the SCT X4 supplied with the kit. A new ECM must be purchased and installed from the dealership in order to install the required supercharger calibration. From Edelbrock Tech tech support. Thanks for your inquiry.
Michael K.
So it adds 317HP to the factory 285HP? So total of 502HP? Thanks!
No, it is a total of 317 wheel horsepower.
Christopher M.
Are there any performance numbers for this?
Edelbrock claims 317 horsepower at the rear wheels, and 277 foot/pounds of torque.