Reviews for Plasticolor 000652R01 Jeep Logo Cup Holder Coaster for Jeep Vehicles

Looks great. But, yeah, having to trim it with scissors is ridiculous. If they weren't priced so cheap, I would dig them.

these didn't fit the front area for my 98 jeep tj console and looked to good to cut so i used some 3m automotive tape and stuck them to the bottom of my tuffy rear drink holder that i fastened on to the back of my factory console. worked awesome and looks very nice. helps hold my yeti in place better also. fyi , i have since discovered if your looking for cup holder mats that fit a jeep tj the 2016 jeep jk smaller front console cup mats fit perfectly. boom!

These only fit the forward cup holder on my 2015 JKU, I needed to trim the other coaster to fit into the second cup holder. Apparently the two cup holders are different sizes. It would have been better if the coasters came in the correct sizes for both cup holders.

They look nice but have to be cut to the correct size to fit the cup holders in the newer Jeeps.

These are nice, you do have to trim each ring, but then just put a small amount of glue in the middle of each ring and place each one in the cup holder. Let the glue dry overnight and it looks great. Can't even tell ring was trimmed.

Had to trim a considerable amount off to fit my JK OEM console

Wouldn’t have ordered these if I’d known they weren’t direct fit and would require cutting. One of them fit tightly and is doable, the other needed trimming and isn’t a snug and moisture-tight fit. Keeping them since I already cut one down and for the price it’s more trouble than it’s worth to return them. Will probably try to find something better at a later date.

Does NOT fit in any of the 4 cup holders in my 2011 JK Unlimited Sahara. Has to trim. Will use but doesn’t look as good. Disappointed that these were listed as compatible with my Wrangler.

Kinda nice but i wish you didn’t have to trim them to fit. It is hard to cut the thick rubber material and get an even cut around the entire circumference. It would be nice if they could be precut to fit your model of Jeep.

Build quality is top notch, however the size of the coasters is too large for the cup holders in the JK. Trimming IS required and this does hurt the stars for the review but if you do not mind trimming the coasters they are a 4-5 star product.