Reviews for Plasticolor 000652R01 Jeep Logo Cup Holder Coaster for Jeep Vehicles

Looks good but difficult to get the exact fit. If you don't get a tight fit it will spin around and stick to your drink when wet.

Look good

Didn't quite fit in our compass, were too big, cut edge off to downsize. Still work well and look good.

Had to cut them to fit, but was easy. Perfect touch’

This is nice simple addition. You have to cut it a tiny bit to fit but it does the job.

Had to trim to fit cup holders, but they work.

Nice coasters, east to trim. Not a snug fit--when they're trimmed they're even too small for the small JK coaster. But they are a nice addition.

Ok

I think these coasters have gotten a bad wrap in the reviews. I held off on buying them for a long time because of the reviews, but I think all the negative reviews are unjustified. Yes, you have to trim these to get them to fit. I used a pair of heavy duty tin shears, and had no problems. My advice is to cut in one continuous cut, all the way around, and will help keep the edges smooth. I did not cut all the way to the inner ring, just chose a consistent point around the design, and cut a little bit off the edges. After they are trimmed, they look great installed, especially at night when the cupholder light hits them. It would be nice though if they were custom sized, or came in a couple of different diameters so you could take a measurement and order the correct site.

Nice, but the rear one has to be trimmed. Wonder why they can’t make them to fit exactly?