Reviews for Crown Automotive 55395101AB Header Opening Seal for 97-06 Jeep Wrangler TJ & Unlimited

Decent product but the adhesive isn't great. I cleaned the old adhesive off very well and after applying this one, it wouldn't stay on easily. I put my hard top on for a few weeks to let it set up then took it off for a few months. The seal moved on the outsides and then setup so the seal is not very good now. I won't buy another one if needed.

This seal does NOT fit '97 TJ. No way to make it fit. Very disappointing to say the least, and what a waste of $

I knew I should’ve just saved for the mopar replacement. Seal wasn’t wide enough, even with stretching, to reach the entire length of the windshield. The adhesive wasn’t strong enough to hold it in place. It also lets in water and there’s a ton of wind noise.

Have you ever been to a dollar store and seen a product marked “slightly imperfect”? That label needs to be put in the description of this product. It doesn’t fit properly on either end, over all its slightly too short, and no amount of pulling or prodding will get it to fist properly. Additionally, I cleaned, recleaned, and then cleaned the header again with alcohol before installing it and the double sided tape may as well have been damp copy paper for as well as it sticks. I don’t understand why not a single replacement product for TJ’s ever fits correctly.

Save your money and buy the mopar part. I wasted money here, it is too short side to side and came rolled up and kinked. Straightened that out and it leaks air snd water 10x worse that my dryrotted 15year old factory original part. I saved a penny to lose a dime here.

Poor adhesive. doesn't fit well at all and I can't get my hard top to latch now without cutting the thing down. I should have just bought the OEM part.

Piece of junk. It was short and would not stick or sit correctly. Had to send it back.