Reviews for Quadratec LED Tail Light Kit for 97-06 Jeep Wrangler TJ

Look good, fit good, work good. Factory wiring was short on the passenger side so had to go in through the inner fender to make the connection. I recommend allowing yourself a little extra time for that side and possibly have a few of those plastic push pin connectors. (I always seem to destroy those things getting them out). The new flasher element was a much appreciated addition and is included.

These lights are fantastic and were super easy to install. It's also really nice that the LED flasher relay was included. The detailed instructions included from Quadratec is by far one of the best I have ever seen.

Easy installation and they look great!
NOTE: When testing during installation these will only work if bolted on. Do not try to test them sub-installed and resting on the bumper. The Jeep IS the ground wire! The lights are definitely brighter than I am.

Super easy to install and a great look on my 04 Jeep Wrangler TJ/LJ!

These tail lights are a huge improvement over the stock tail lights. They replace the factory tail lights with no modification needed. They are compatible with rear tail light guards for TJ's. If you have tail light guards and want to keep them with these LED tail lights you will need to replace the factory bolts with ones that are 1/4" longer. This will give you the ability to maneuver the tail light housing, wires, and light guard for a secure fit.

These were easy to install once we figured out how to mount them with the euro tail light covers. We used carriage bolts to hold the bolt in place so we could tighten them down from the other side and drilled the holes out to 1/4” in the body. The carriage bolt also allowed us to slide the lights into the covers with the LED panel on instead of working around the LED panel. Super easy install and very bright! Looking forward to using the reverse lights at night as well.

Plug and play. Very bright and look great. Highly recommend.

Easy install - work great with provided flasher module. A subtle safety/style update after my stock units rusted out internally. Would recommend!

Just installed these on my 2004 TJ.
Took about 40 minutes because the passenger side is a bit difficult.
I pulled the plastic inner fender cover out of the way and used a fish wire to guide the new wires down to where i could plug them in to the connection.
They work great and i really like the bright backup lights.

Put on sons jeep plug and play.