Reviews for Corbeau D1038T Driver Side Complete Seat Bracket for 91-95 Jeep Wrangler YJ
Worked great for installing 05 PT Cruiser seats in my YJ. With the factory brackets the seats sat too high and were slightly uncomfortable for me with short legs. These lowered the seats about 3 inches. I removed the sliders that came with the bracket, and drilled new holes for the width of the PT seats. I had the same small problem others talk about in the leg being short and not matching up with the floor pan, but it wasn't an issue. This bracket also allowed me to weld on an extra piece under the seat to mount my little stereo amplifier out of the way and hidden.
Fits great
Fits great except the inside front mount is an inch too short so it doesn't touch the floor but it's stable with only 3 bolts so happy
Front inner leg needed a spacer but a great product
they fit only if you bend and pry to get the mounting holes to line up.
i used corbeau seats.sat way low and flat added 1 1/4 inch spacer to front to give a bit of angle to make the seat more drivable. also realized that frame is so low that the seat back adjuster hits the seat belt base. seat is far enough back for me (6 foot tall) if you want the seat to go further back you will have to add 1 inch spacers on the four legs for the seat adjuster to be able to clear the seat belt housing. with today's cad computers this should have had better fitment
Slides were too short for my factory seats. ? Had to drill bracket to accommodate my old slides. Once done, mounted and look nice
Had to return it moved me to far to the outside and to high. Thanks to Quadratec great customer service it was no problem returning.
Got three of the four legs to bolt down, the rear leg sits a bit high so either going to have to stack washers or make some sort of spacer. Also going to have to drill new holes for the sliders. Seat sits too close to the door striker.
Doesn’t form to the floorboard and the bolts didn’t line up very well pretty disappointed with the quality of it but made it work. Would buy again
Did not fit form of floorpan. Driverside rear bracket 1 inch too short and would require spacer. Slides do not even remotely for a stock seat, tracks not set wide enough to match up to seat holes and bracket not drilled to move. In addition seat slide mounting holes to seat are 13" center to center. Seat bolt holes are 14". Total junk.