Reviews for Rough Country MLC-6 Multiple Light Controller for 18-22 Jeep Wrangler JL & Gladiator JT

I was really impressed with the quality for the cost but there are some minor Mods you must do. And what ever you do if you have the dash mount, start here and not the other way like the instructions say. I had to pop off the panel under the steering wheel as well. But the switched themselves would not fit so I had to put washers under the bottom half bolted to dash. Yes I left the rubber liner in. This part could have easily been fixed has the person who designed it tired to install it. The main power cords to the battery could have been longer so you can lay them out better.

I didnt see anything close to this price for this quality. I gave it a 3 since I wast aware of what I was getting into.

20 Gladiator Rubicon
Hope it all made sense

The insulation is not easy nor is it straightforward they do not take into consideration those who have a manual transmission. I do not have that little twist tab that you just pull out and run the wire through because I have a manual transmission. That’s where the master cylinder for the manual transmission fluid is. Does anybody know of a way to install this without taking apart half my jeep trying to find a hole to
run this wire through.

This was not designed for a manual transmission (When going through the firewall, manual trans uses the access cut out they designed it with), when calling RC for support, the "Assistance" was laughable. When finally installed, the numbers you connect to under the hood are labeled 1-6, but the control panel in the jeep is wired right to left (Connection 1 is switch far right, connection 6 is switch far left). Poor QC all in all