Reviews for Quadratec QRC Front Winch Ready Bumper for 18-24 Jeep Wrangler JL & Gladiator JT

Love the look of this bumper.

It was fairly easy to install. It looks great. Make sure you mount the winch first before you stab the bumper. I mounted the Badlands Apex 12000 it's tight but fits fine.

Love this bumper, looks great on my 2021 JL. Easy install, added the ResQ Teton which, fits like a charm. Pulled Diode Dynamics fog lights from old bumper and installed here easily. Great bumper and always great Quadratec service.

This bumper is tough. Zero damage after a collision. I am a lifelong fan of Quadratec now. I reccomend to all my friends. Install was simple, my son and I knocked it out in about 3 hours.

*Apex Badlands 12k winch is a tight fit, be mindful of your wires.

Great bumper. Only problem is winch lies too close to grill.

Execellent Bumper! went on easy peasy. Really appreciated the welded on Studs so that you dont have to finagle a piece of tape or clear plastic to hold it in place. Just lift it up and stab it on, the nuts are welded on also , I put it on by my self.. now I suggest putting the winch on first , you'll prob need help with the added weight.
This went on my 23 Gladiator Mojave.
**Attention Mojave owners.** NO MODS NEEDED . despite what you read, NO MODS NEEDED to put back on your factory Skid Plate.. Just put the front 2 on like usuall.
THEN.. It brings things in alignment in the back but leaves about a 1" gap. Hey No Prob.. just grab your floor jack, crank it up with a little pressure Viloa.. all 4 bolts are on without cutting or Moding your factory nice thick front skid that protects your Fox Reservoir's...

The bumper was exactly what I was looking for. The directions missed the removal of old brackets but once removed it fit. Did have trouble lining all the bolt holes up but once on looks great. Mounting winch after was difficult, would do it prior to mounting next time.

Fast shipping. Great finish on the bumper and tubes. I love the welded end caps on the tubes. Much better than the plastic end caps on some of the competitors bumpers. Awesome mix of rugged old school look with new school recessed winch mount. I mounted a Warn VR EVO 10k to this bumper and it was a bit snug between the winch wires and the bottom of the grill. Had to loosen and flip the winch wires so they came up from the bottom to the winch and this gave me the clearance needed between the grill and winch. It also made for a really clean look hiding the wires. 100% satisfied and would recommend to a friend.

Extension out to edges of fenders. And looks great!

Looks like a solid bumper welded bars not bolt on.