Rugged Ridge 11232.52 Elite Fast Track Windshield Light Bar Mounts for 07-18 Jeep Wrangler JK

easy to install and looks good my only issue is the plastic wire cover at the bottom do not sit flat against the frame

Solid 4 stars. Good construction and assembled easily. Mounting was a quick too.

Installation:
The parts slide and bolt together easily - no fighting or pushing.

Make sure you slide the conduit sleeves on before bolting the brackets to the A pillar, and watch the nuts. I put a piece of tape below to catch them.

The A pillar fit was near perfect with maybe a little left to be desired with the wire cover ups that go down between the wipers and the cowling. No big deal but where this gets 4 stars instead of 5.

Wind Noise:
I used an auxbeam 50 inch bar, and had to source some rubber washers (3/4ths of an inch worth on each side), but it looks good.

I followed all the advice on the interwebz on the wind noise, and elected to use the automotive trim mouldings to keep noise down. there isn't any trace of excess noise.

Overall a great setup. Time will tell on rust and other issues.

Bought this as a set with the Rugged Ridge 50 inch light bar (also to be reviewed). Yes it bolts in easily, however the plastic wire cover that goes up the mount is worthless. In the 100 degree heat, it turns in to a limp noodle and flips around. The hard plastic cowl pieces that attach at the bottom of the mount do not seat properly along the windshield frame causing them to pop against the windshield at speeds over 40 mph. Finally at the top, there is a 1/4 inch gap which allows the wind to whip around causing a uhh pitch almost feedback noise. It’s not from the bar but from the mount. The bar was silenced. Don’t waste you time or money in this item. Spend a little more Nd get a better mount. I will be returning this item and do not recommend.