Skip to main content
Home » Jeep Driveline » Drive Shafts & Hardware » Drive Shafts » Crown Automotive Front Drive Shaft

Crown Automotive 52105728AE Front Drive Shaft for 05-06 Jeep Grand Cherokee WK and Commander XK with 4.7L and 5.7L Engines

Quadratec Part #: 52302-0028
Crown Automotive Part #: 52105728AE
Description
If your Jeep Grand Cherokee or Commander front drive shaft is bent or you feel its easier to just replace the entire shaft when a joint goes bad, then the Crown Automotive Front Drive Shaft will get you back out on the road. As a factory replacement this shaft has the same CV joint on the transfer case end and u-joint at the axle. These joints allow for maximum suspension articulation that the factory had in mind. If a there is an issue with your original shaft you will hear clicking while driving or may feel a vibration that changes with speed. These issues left unattended to could do further damage to axle components or the transfer case.
Details
Collapsed Length: 34"
Extended Length: 36.5"

Factory Replacement: Made to the same length and standards to guarantee it runs like the original and does not need any additional yokes or flanges to install.

Full Assembly:Balanced at the factory joints installed

For Stock Suspensions: The length this is made to accommodate factory suspensions and drivetrains.

Installation Notes
Installation Difficulty:
Skill Level 2 IconLevel 2Intermediate
Parts Included
Front Drive Shaft
Warranty
12 Month/ 12,000 Mile Warranty
  • Engine: 4.7L, 5.7L
  • Location: Front
  • Shipping Weight: 18lb
  • Shipping Dimensions: 36in x 5in x 5in (L x W x H)
  • Jeep Commander (XK)

  • 2006 Jeep Commander (XK)
  • Jeep Grand Cherokee (WK)

  • 2006 Jeep Grand Cherokee (WK)
  • 2005 Jeep Grand Cherokee (WK)
Share Your Thoughts
Review Summary
5
Based on 1 reviews
Shared Media
Questions

Customer Submitted Photos

Crown Automotive Front Drive Shaft Reviews