Quadratec Part #:
52302-0026
Crown Automotive Part #:
52105884AA
Description
If your Jeep Grand Cherokee's front drive shaft is bent or you feel its easier to just replace the entire shaft when a joint goes bad, then the Crown Automotive Front Drive Shaft will get you back out on the road. As a factory replacement this shaft has the same CV joint on the transfer case end and u-joint at the axle. These joints allow for maximum suspension articulation that the factory had in mind. If a there is an issue with your original shaft you will hear clicking while driving or may feel a vibration that changes with speed. These issues left unattended to could do further damage to axle components or the transfer case.
Popular Similar Items
Details
Factory Replacement: Made to the same length and standards to guarantee it runs like the original and does not need any additional yokes or flanges to install.
Full Assembly: Balanced at the factory joints installed
For Stock Suspensions: The length this is made to accommodate factory suspensions and drivetrains.
- Engine: 4.0L, 4.7L
- Transmission: Automatic, Manual
- Location: Front
- Shipping Weight: 17lb
- Shipping Dimensions: 37in x 5in x 5in (L x W x H)
Jeep Grand Cherokee (WJ)
- 2004 Jeep Grand Cherokee (WJ)
- 2003 Jeep Grand Cherokee (WJ)
- 2002 Jeep Grand Cherokee (WJ)
- 2001 Jeep Grand Cherokee (WJ)
- 2000 Jeep Grand Cherokee (WJ)
Share Your Thoughts
- Shared By Others
- Share a Photo
- Ask a Question
- Write a Review