Reviews for OMIX 13510.70 Foam Blocker Seal Kit for 11-18 Jeep Wrangler JK

If you have a JK, you probably need this set, because chances are your freedom panel seals are worn out. Mine were so worn out that it was hard to figure out what pieces go where, and that's my only criticism: no instructions. However you can pretty much match them up with the old pieces. I found some other resources of how to do it so that made it easy. Just make sure you remove the old pieces, use some rubbing alcohol to get any residue off, and then stick these on and you're done! Super easy maintenance item to check off the list!

Easy to install

Not sure yet. Haven't used it yet.

Hopefully will take care of my moisture problem.

Good reviews

Price

Bought this kit to help stop leaking water in my floorboard. Worked great. Was a little tricky matching up the pieces because mine were distorted. Instructions showing shapes and locations would help. Looked online and found some information on YouTube.

Great

You need to find the Jeep Wrangler Diagnosis & Repair Manual Water Leaks .pdf to determine where to position the pieces. You may not need to use all of them.

And, yes, this kit DOES work on the 2010 hardtop freedom panels. I just replaced the foam on my freedom panels and, so far, no leaks. Now to fix the foam on the hardtop itself to stop the leak at the top of the rear doors.

PS... I replaced the strip between the freedom panels at the same time. I ended up with the three tubes and three foam strips left over.

Fixed my water leak and helped with the wind noise in the cab