Reviews for WARN 101255 Winch Mount Plate for 18-23 Jeep Wrangler JL and Gladiator JT with Factory Steel Bumper

Good quality Plate Install was tricky but doable in the driveway.

This kit is excellent! Everything was very straightforward on my 2020 JL with factory steel bumper. I did not have any clearance issues or fastener alignment issues. Installation took several hours, but it wasn't particularly difficult. I installed a Zeon 10-S Platinum and everything fit great.

Looks sleek and almost like it could've come stock!

It work and fits as described all blot on just had to man handle it a little is all

Fairly easy install... only difficulty was in getting bumper back on site to factory misalignment of some bolts, but went in nicely one once a couple bolts were loosened on the outside rails.

Very nice and easy to install winch mount. Instructions are straight forward and to the point. Mounted a Smittybilt 10K x20 winch, everything was bolt-on with no problems.

According to the mechanic who put it on, it all went as it should. It does support the Stealth winch very well.

It is good product easy to install

Very sturdy and high quality but a couple of install notes (2019 JLRU with factory steel bumper).
As a prior review, yes there is TWO welded nuts that are on the factory skid plate bracket that don't allow the WARN bracket to be installed. Easy method is to clamp the lower welded nut in a bench vise and smack the bracket with a dead blow hammer. The nut pops right off.You could prob snap the nut off with a breaker bar also.
The bracket sets the bumper approx 1/4 " further out. This causes the rear 2 skid plate bolts to be misaligned. Drilling a large hole to open up the rear to slot it works perfectly..

It's a little pricey, but its must have