« Back to product
Megan E.
Can this support the 12,000lbs winch Quadratec model?
Yes, it can. Thanks for your inquiry.
KENNY W.
I bought a rugged ridge spartan front bumper
What size D-rings do I need for it?
3/4" D-ring that use a 7/8" pin size will be a correct fit. Thanks for your inquiry.
Daryl E.
Can I flat tow my Jeep behind a motorhome using the D ring brackets on this bumper?
No, it is not flat tow rated. Thanks for your inquiry.
Lori R.
Will this fit a ‘94 wrangler?
Sorry but this is only approved for the 2007 - 2018. Thanks for your question.
Albert J S.
Do you need any extensions or other parts to reinstall the stock fog lights?
No, extensions are not required for the fog lamps.
Bryan L.
If I’m not installing a winch will there be a big hole where winch is supposed to be? I couldn’t tell in any of the pictures.
There will be a defined area (depression with mounting holes) where the winch would go if you install the winch plate. If you leave the winch plate off then you will have a clear hole all the way through the bumper.
GREGG S.
Does the vacuum pump need a relocation bracket?
The vacuum pump needs to be addressed, You can move the pump or use a cut-off wheel to remove a tab on the original bracket. Refer to page 5 of the installation instructions.
Robert B.
Is there room to install the front license plate?
The space between the fog lights is only about 10". A standard plate at 12" would cover some of the fog lights. If you are mounting a winch you can use a fairlead plate mount that clips onto the rollers or hawse fairlead.
Ron C.
What is the fairlead hole spacing on this bumper
10" center to center.
James R.
Does the over rider bar bolt on or is it welded on
The over rider bar is a simple bolt on installation.