Reviews for Rugged Ridge Etched A-Pillar 4 Switch Pod Kit for 07-18 Jeep Wrangler JK Left Hand Drive

Got the Piller light switches put 5 switches in got them wired up only using 2 other ones for more add ones

Had some issues getting the pre-marked tabs cut out. Finally used a heated hobby knife. Make sure to cut on the inside of the etching and trim as needed to assure the switches fit snugly. Looks great and works well. Color match may be off slightly but is hardly noticeable.

Excellent quality and a worthwhile investment for your Jeep. Only word of advice is I used a dremel to properly cut out the switch openings because I was afraid of damage since I felt their knock outs were not scored deep enough.

Fits great. But use a dremel to cut out the opening

Fit right in place of the existing A pillar cover. Use a dremel tool to cut out the switches. Switches could use a wiring diagram instead of having to meter them out. Color matched my 09 JKU Sahara interior (dark gray).

Easy to install and fits good. Very pleased

Fits great

Simple installation

Happy Happy Happy with this item.

Hard to cut