Reviews for Rugged Ridge 1-1303 Front Bump Stop Kit 07-18 Jeep Wrangler JK

excellent

Installed these in a 2010 Jeep JKU. The installation was fairly straightforward though I expected a much bigger project. The hardest part was seating the bump stop without it going in crooked. I supported the truck with a stand on the frame behind the front tire, disconnected the sway bar, removed the tire and jacked under the lower control arm bracket on the axle. At full droop, using a pry bar, I was able to open up the spring enough to get the BS in. Then I stacked small squares of 1x3 inside the spring up to the BS loosely aligned in the hole. Then I jacked up the car and used the weight of the vehicle to hold the BS in the seat. I sprayed WD40 up around it and down through the hole in the spring mount so it dribbled down INTO the BS cup from above. Then I jumped on the bumper. For the most part this seated the BS. Then I would lower the jack, remove some wood and if the BS was crooked but partially seated I used a pry bar to finish seating it all the way. They are very hard and not pliable. Good news is they should outlast the truck.

easy install perfect for factory replacment

too hard.

Too stiff