Reviews for Rugged Ridge 11650.20 Front Fender Guards for 97-06 Jeep Wrangler TJ & Unlimited
These things are a bear to get on and fit right. First they require a lot of trimming to make them look as if they belong there (fit correctly) and the adhesive tape is junk (I used 1 inch wide industrial grade 2 sided tape) , also the stock turn & park light screws do not come close to being long enough (I used 1 3/8 x 8 screws) . With that said , I was able to get them on correctly (looks good). Some may want to get a pro body shop to install them.
Cheap plastic. screws are not long enough and holes don't match up
Poor fit. Not like other parts of this kind. Rear corner guards were perfect fit and easy install. Would not recommend for the Jeeper looking for easy install and good fit.
Hello, I received these guards yesterday and started to mount them. I quickly found out that there was somthing not quite correct with one of then. Namely the left one seen from the front of the Jeep. I pre-fitted it and saw that there is a 10mm gap between the guard and the frontgrill. You can see it on the photos. You can also see that there is a larger gap on the right side than the left for the turn signal indicator. This means that it will never fit and the 3M tape will never stick to the fender. The right side fits much better even if there is a approx. 1mm gap. I also measured the guards at the lower part to see if there was a difference and the right side is 38cm and the left side is only 37cm. So clearly there is something wrong with the left side guard. You have to investigate this before you ship out others. You must have had other complaints about this since they ar made out from the same moulding tool? My question is what can you do about this for me? I need a left side that has the same measurement as the right side.
Cheaply made and looks like crap when installed. The tape won't hold it since the cheap plastics isn't formed correctly. Do yourself a favor and find s better product.
They were supposed to fit a 2006 Jeep Rubicon. They did not fit out of the box due to the stock rubber fender extensions. The lips of the guards were too large to allow them to sit flat on the fenders. They required extensive cutting and shaping to get them to fit properly. Additionally the inner curve that rests against the headlight area matched the Jeep on only one side. There was a half inch gap on the other side. I will not buy Rigged Ridge again.