Skip to main content
Home » Jeep Engine & Fuel System » Fuel Sending Units & Lines » Fuel Sending Units » Crown Automotive 20-Gallon Sending Unit Assembly
« Back to product
Will this pump work with a Holley sniper fuel infection kit? Do you know what the fuel pressure is with this pump? Thanks
No, it will not. This is a stock sending unit for YJ equipped with 20 Gallon tank. A Holley Sniper is for CJ and the fuel sender required for it is in the following link. Fuel Pump Module for Sniper Thanks for your inquiry.
Where is this product manufactured?
This is manufactured in Taiwan.
Will this work with the 15 gallon stock tank?
If your tank is a plastic 15 gallon tank from these years then yes it will fit and work with the gauges
Will this fuel pump work with fuel injection?
As a direct replacement for 91-95 Wrangler's that is its intended use.
Will this pump work for an LS Swap? 58 psi is needed.
The pressure rating on this fuel pump is from 70 psi minimum to 120 psi max
What are the ohm readings for full and empty?
86-90 full/ 0-3 empty
Do you know what the flow rate and pressure is for this pump?
Flow rate is listed as 40 (min) to 55 (max) GPH and pressure is 70 (min) to 120 (max) psi
I am adding a TBI kit to my '89 YJ 4.2 and I would rather not add the included external fuel pump to the frame rail. Will this fit in my 20 gallon tank? My YJ is an Islander and I understand that they all had the 20 gal tank. My engine also has a modified 4.0 head.
This will fit the tank as long as it is a poly tank which it should be. Any plastic tank will have the rectangular opening at the top as opposed to the round opening on steel tanks
my 95 yj 2.5 4cyl has a 15 gallon gas tank, will this work? per description it appears setup is only for 20 gal? shane 843-615-6859 [email protected]
Yes this will work with the original plastic 15 gallon capacity tanks.