Skip to main content
Home » Jeep Driveline » Drive Shafts & Hardware » Drive Shafts » Tom Woods Front Drive Shaft
« Back to product
is this stock length? Im lookin to do a shackle reversal kit and from what i have heard is that i will need a 6-8 inch longer drive shaft. if this doesn't work do you have one that will fit my application?
Yes, it is stock in length. For rear drive shaft, it is important to take measurements after the lift is installed. https://4xshaft.com/blogs/general-tech-info-articles/driveshaft-length-after-lift. Thanks for your inquiry.
1. What is the outside diameter of the shaft? 2. Will it fit 39-1/2 inch t-case to front diff?
This driveshaft is 2" diameter 0.120" wall USA made DOM tube. The compressed length is 38" and extended length is 41". Thank you for the question.
Does this application work with 2.5 manual? Says automatic on 4.0 and 4.2 nothing about 2.5.
Yes for 87-95 this is good for the 4-cylinder with AX-5 Transmission.
Will this fit my 1990 Jeep Wrangler Sahara 4.2l straight 6 manual transmission? Or is this only for a automatic transmission?
This for Automatic transmissions only. Please see link below for Tom Woods Front Drive Shaft for manual transmissions. https://www.quadratec.com/products/52300_05_07.htm
What is the overall expanded length? And does this come with the ujoint installed or do you need to buy new ones?
The overall length expanded is 41.5" and yes the u-joints are included and installed so your installation cost and time is reduced.
Does this fit 1989 yj with 4.2L and manual transmission?
This would not fit. 52300.05 is the correct drive shaft for your application, please see : https://www.quadratec.com/products/52300_05_07.htm
Can this part be used on a 1995 YJ with a 4.0L and automatic transmission?
Fits the Following Applications: 87-95 Wrangler YJ with 2.5L Engine 87-95 Wrangler YJ with 4.0L or 4.2L Engine & Automatic Transmission
Does this front drive shaft fit a 4Cylinder 5 Speed Manual Transmission 93 YJ ? It doesn’t specify transmission type for the YJ with a 2.5L engine
This works with both manual and automatic transmissions in Jeeps equipped with 2.5L engines.