« Back to product
TODD H.
Will this work with a 4" or 6" lift?
Yes it will. For that size lift we would suggest a Slip yoke eliminator and extended rear drive shaft though. Thanks for your inquiry.
Dennis C.
will this fit a 2.5 yj ? im looking to lengthen my stock one by 6-8 inches. this would fit my application if it will bolt up
No, it will not. A drive shaft of that length will require a customized order. We do not carry front drive shafts with 6-8 extra inches available to us. Sorry for the inconvenience.
Dan D.
Will this driveshaft fit my 4 cylinder 95 yj wrangler
No, this will not. Thanks for your inquiry. This application would be correct for 2.5L in a 1995 YJ. YJ Front 2.5L Drive Shaft Thanks for your inquiry.
Robert E.
What is the collapsed size?
Compressed is 40" and extended is 43".
JOHN S.
Whats the coating?
These are bare steel
Aaron L.
Is this a direct stock replacement? Or are the joints larger then stock?
This is a direct replacement with OEM-sized 1330 u-joints. It is good for 0-4" of lift.
Bo W.
What is the size of the U-joints?
This uses 1310 u-joints
Ryan F.
In the picture it shows it with U joints. Does it include U joints?
Yes, u-joints are included.
Daniel A.
What is the tube size? The stock drive shaft is about an inch in diameter. It's very close to the exhaust pipe.
Per the manufacturer, this has a 2.5" outer diameter.
Spencer N.
What is the length?
The compressed length is 40", and the extended is 43".