Skip to main content
Home » Jeep Lift Kits & Suspension » Shocks » Monotube Shocks » Bilstein B8 5100 Series Gas Shock Kit
« Back to product
I’m putting 2” spacers and a 1” body lift will these be a good fit for that? Can I run these for the in-term or should I put them on at the time I install the spacers?
They are compatible with 2" of suspension lift. They should not be installed until the correct amount of suspension lift has. Thanks for your inquiry.
Will these shocks work with stock springs and teraflex leveling kit?
Likely not. Teraflex leveling kits are not 2-3.5" of lift. Thanks for your inquiry.
How does the warranty work I got one of my shocks is leaking
Please see the following procedure guide for Bilstein warranty support. Bilstein Warranty Terms . Thanks for your inquiry.
Will this fit a 2013 wrangler unlimited with a rough country 3.5" lift?
Yes, they will fit with that lift. Thanks for your inquiry.
Would these shocks work with my ReadyLift leveling kit? 3.0"F / 2.0"R
Yes, they will. Thanks for your inquiry.
Will these shocks fit my 2015 Rubicon "Hard Rock" edition; factory height?
No, they will not. The Jeep must have at least a spacer lift kit to run this length of shock. Regardless of trim level. Thanks for your inquiry.
What are the Bilstein part numbers for the front and rear shocks in this kit?
24-146708 and 24-146715
Will these fit a 2008 wrangler (2dr 4wd) with 32” tires and no lift modifications? Thanks
No, these are for 2-3.5in lift only
Will these shocks fit my 2013 Rubicon without a lift kit. Stock height.
No, these are for 2-3.5in of lift.
I was wondering what the extended length on these were? Thanks
The front are 14.98" collapsed and 24.63" extended. The rear are 15.39" collapsed and 26.38" extended.