Skip to main content
Home » Jeep Interior » Heating, Ventilation & Cooling » Cables » Crown Automotive Control Cable Kit

Reviews for Crown Automotive 5463657K Control Cable Kit for 78-86 Jeep CJ-5, CJ-7 & CJ-8 Scrambler

< Back to the product
Joshua B.
12/2/2020
3

They are fine, my only issue is that it says you can easily upgrade to billet knobs but you can't. It is possible but it is a pain. I ripped the rubber off of the existing knobs, then crushed the plastic in a vice until I could pull it off, as they are glued on. Then I could fit other knobs in place.
Kenneth G.
5/15/2021
2

Very cheaply made. The center circle decal in one of the knobs is off center and the adhesive they used to adhere the knobs squirted out the side and dried. They seem to work fine, but very poor quality overall.
Kenneth R.
11/24/2022
1

Cracked trim rings on 2 out of 3 of the knobs. Cheaply made
Edward S.
7/5/2020
1

Absolute junk. Cheap plastic rods. Would not put these on my Jeep ever. Knobs are molded onto ends and are not removable so cannot install my billet knobs.
John M.
11/30/2017
1

I installed the new cables and the first pull two of the nobs came off in my hand. I had the heater box out and had just lubricated all the actuator doors. The cables seem to be slightly thinner then the old stock ones I had. I did epoxy the nobs back on and they seem to be holding.