Reviews for Rock Hard 4X4 RH5011 Vacuum Pump Relocation Kit for 12-18 Jeep Wrangler JK

Needed to relocate my vacuum pump after getting a 12000lb winch to mount to the QRC Winch Ready Front Bumper.

This bracket, when installed per documentation, would still put the pump slightly inside the same space as the winch plate on the QRC bumper (blue circle), so I had to rotate it back a little bit, pivoting on the stock bolt location (red circle), and not use the second bolt (green circle). I made sure to tighten the 1 bolt extremely well to prevent movement. After this, I was able to mount the winch with no fitment issues.

Most other relocation brackets require disconnecting the vacuum pump hose, which I was unable to do (it was really stuck).

worked out very well. relocation was easy.

Well engineered and made piece of kit. This was my first time even looking at the vacuum pump on my JK. Since I was unfamiliar with relocation, I did spend 10 minutes manipulating and orienting the new bracket to make sure I was mounting it ok. Works excellent with my new rock hard bumper, fully clearing bumper, winch and element on vehicle. Very well made and finished

Good fit, easy to install. I was a little unsure on how sturdy it would be as it only connects to the existing rear tab, after installing it feels very sturdy.

Worked fine. I mounted in another location under the hood rather than the factory position because I don't like the pump being so low to the ground.

Rotates the vacuum pump out of the way of winch/bumper without having to move everything under the hood.

Only came with (2) nuts. It needs (3) nuts. Other than that it fits with no issues.