Skip to main content
Home » Jeep Winches, Recovery & Safety Gear » Winches » Smittybilt XRC GEN3 9500 lbs Winch
« Back to product
Will the fairhead bolt directly to winch or is it only to bolt to an opening in bumper?
The fairlead will mount to a bumper fairlead attachment or a winch plate with fairlead mount. Thanks for your inquiry.
Does this winch have a ball hitch mount available for purchase?
I would expect that this cradle mount from Warn for receiver hitch mounting would also have a high likelihood of accomodating a Smittybilt winch Receiver Winch Mount Thanks for your inquiry.
Does this wench require a mount platen for my jeep 2020 Wrangler 2 door JL?
If you have the factory base bumper then yes you will need a winch mounting plate. Thanks for your question.
Will this fit on your Quadratec QRC Front Bumper for 07-18 Jeep Wrangler JK Unlimited 4-Door?
Yes it will. It appears that on the QRC https://www.quadratec.com/p/quadratec/qrc-front-winch-ready-bumper-jeep-wrangler-jk has an image shared by a customer of a successful fit with ample clearance.
how much does this winch weigh?
Sure - just click on the winch you prefer between these two, then click on the "Specs" tab. This will show the weights, among other measurements. The steel cable version is approx. 84-lbs shipped. The synthetic rope version is approx. 60-lbs shipped.
Where is this winch made
This winch is made in China.
whats the physical dimensions? Mainly total width..
Please see all the actual winch dimensions on page 18 of the install manual. https://www.quadratec.com/sites/default/files/installation_instructions/smittybilt-xrc-gen3-winch-manual-install-instructions.pdf
i have the smitty built winch xrc 9500 what diameter is the the rope I need to replace mine. thanks
This winch included a 10,000lb 3/8" X 94' synthetic rope. https://www.quadratec.com/products/92122_910X_PG.htm
Do I need a mounting plate with this winch ? I have a 2020 JLU Rubicon with steel bumper
Yes, you will need a winch plate.
Rubicon anniversary bumper, does this winch use the same mounting bracket as Warn? Any extra parts if I want to wire this to an S-Tech switch? Thanks

This winch has the same mounting footprint as Warn, 10"x4.5".
You should not need anything extra to use this with your S-Tech switch setup.