Reviews for Fishbone Offroad FB13138 Rear Quarter Panel Chip Guards for 18-20 Jeep Wrangler JL

Could offer protection when I lose my factory bumper.

It is a simple and good product.

Quick and easy, no nonsense solution to protect the area right behind the rear tire. Ever since I replaced the factory bumper I've been thinking about how to protect this area. I was about to coat it with bed liner or undercoating, but this item showed up in my email. It takes about a minute to install.

Would have been nice for fishbone to go back to the drawing board and redesign the quarter panel for a little bit of extension specially if you are not rocking a full width rear bumper. Protection is there would be cooler to extend just a little bit more

Replaced the rear bumper on my JLUR wanted to protect the exposed seam from chips and rust. This is a reasonably priced solution, though I wish it covered a bit more of the seam. But it will do the job well enough.

I put a new bumper on my 23 Willy's, which leaves a unfinished space between the bumper and wheel well. This helps, but I wish it was bigger and covered the whole bottom area.

These didn't fit on my 2021 JLUR