Reviews for Quake LED QTE558 Blackout LED Replacement Tail Lights for 18-20 Jeep Wrangler JL

Direct Factory Replacement and blacked out appearance

kick ass!

These lights ARE compatible with the blind spot monitoring system. Instructions were good but keep in mind you must remove the sensor from the old fixture, it’s two additional screws... fairly straight forward process. You might have to go into the Uconnect dashboard settings and turn off and back on the BSM to reset the module. My neighbor didn’t have to, but I did. The lights look awesome and are completely integrated.

I really like these lights! They seem well built and solid and I like the look. Installation wasn't that difficult, but the instructions need to be better. The pictures on the install sheet are small and grainy and difficult to see what they are looking at. They were also a little vague in spots, like how to clip the L bracket with resistor onto the pinch weld behind the tail light. Also, there was no mention at all about how to disconnect and reconnect the cable (there are two plugs so you have to figure which one to unplug). You figure it out eventually, but the install could be a little faster if the instructions were a bit better. OVERALL, the lights work just great, they look great and I'm happy with them!