Skip to main content
Home » Jeep Driveline » Ring & Pinion » Ring & Pinion Kits » Yukon Gear & Axle Front & Rear Ring and Pinion with Master Install kits
« Back to product
So I won’t need a new carrier if I have 3.55 gears already?
That is correct. A front carrier is required only for models with gear ratio of 3.54 and numerically lower. Thanks for your inquiry.
I have a dana 30HP and 8.25 with 3.55s. I want to go to 4.56. Besides this kit, what else is needed so i can order all at once?
If you are equipped with 3.55 gears originally, you will not need to add anything to this kit for your re-gearing project. Thanks for your inquiry.
So I have a dana 30 in front and 8.25 in rear with 355 ratio do I need a new carrier if I get new gears of ratio off 488 or 456 please let me knw
For the front, you will. The rear carrier does not need the change. Thanks for your inquiry.
https://www.quadratec.com/p/yukon-gear-axle/grizzly-locker-jeep-wrangler-jk-tj-yj-cj-xj-zj-wj-w-dana-30-front-axle-w-373-and So can I not pair this locker with this gear set up since the spline count is different? If not what mechanical lockers can I pair with these gears for front and rear
These will fit with that locker. The axle spline count is 27, and the pinion is 26, so sorry for the confusion. Thanks for your inquiry.
Assuming I have a 3:73 ratio carrier in my Dana 30. Can I reuse the spider gears with the 4:56 ring and pinion?
Your factory differential case and the spider gears within are compatible as long as your factory ratio is 3.73 or higher. Thanks for your inquiry.
If I am planning on using the PowerTrax GT443027 Grip PRO Limited Slip Traction System for 27 Spline Dana 30 Front Axle w/ 3.73 and Numerically Higher Gear Ratio, please verify I do not need to get a new carrier since i am switching from 3.55 to 4.88 ratio gears (since the PowerTrax is it’s own carrier)
Correct. No new carrier will be needed as the PowerTrax is a carrier in and of itself and is good for 3.73 and numerically higher gears. If you were using the stock carrier, you would need to change to a carrier for 3.73 and numerically higher.
is this gear set offered in a 4:10 ratio?
No, Yukon only offers this kit in the two ratios shown. They do not offer the stock ratio ranges.
Is this gear set for high pinion front
Yes, it is.
Is the gear set for the D30 reverse rotation gear. I have a HP30 an gear need to be reverse rotation
This particular pair of gears are for the Cherokee XJ. All 84-01 Cherokees had reverse cut gears for the Dana 30 front axles.