« Back to product
Matthew S.
Does this bumper allow for a tow hitch to be mounted in the stock location?
![](/sites/all/themes/quadratec/logo.png)
Yes, it does. Thanks for your inquiry.
Antonio Z.
Can I put this rear bumper on my stock JLU sport
![](/sites/all/themes/quadratec/logo.png)
Yes, you could. Thanks for your inquiry.
Christian C.
Will this bumper be ok to run with 37s? Planning on getting the talegate reinforcement. Anything else needed?
![](/sites/all/themes/quadratec/logo.png)
You will need a tire carrier bracket like this model to handle a 37" spare tire. Mopar oversized spare tire carrier.Thanks for your inquiry.
Andrey S.
Is the steel rear bumper now compatible with back-up sensors?
![](/sites/all/themes/quadratec/logo.png)
No, it is not.
Bill S.
Do you sell the complete Rubicon rear bumper with the holes for the back up sensors
![](/sites/all/themes/quadratec/logo.png)
No, unfortunately we do not have a kit with all of the components for a sensor rear bumper. We only offer the individual replacement parts.
Mike G.
Do the rear Mopar steel bumpers now have backup sensors? I saw one at the dealer that sure looked like it did.
![](/sites/all/themes/quadratec/logo.png)
Yes, you can get the steel bumper with sensors as a factory option with the Safety Group installed.
Wayne L.
I have a 2020 JL Sport with the plastic rear bumper. I bought the MOPAR steel bumper for the front and it bolted right on. If I buy the MOPAR steel bumper will it bolt on too? Or is more hardware needed? If I take off the rear bumper end caps will it line up with my Sport? Thanks.
![](/sites/all/themes/quadratec/logo.png)
This will bolt right on, this kit is complete with all of the new hardware that is needed and not found on your plastic OE bumper
Mike W.
I have a 2021 Willys. Can the end trim piece that doesn't line up be left off? or do they need to be installed?
![](/sites/all/themes/quadratec/logo.png)
They can be left off as needed.
Larry O.
Will this fit my 2020 Wrangler unlimited Willys
I am concerned that the plastic bumper ends wont line up
Thanks
![](/sites/all/themes/quadratec/logo.png)
It will fit, but you are correct the lines will not match up with the fender flares. The bumper will be wider
Serafim T.
Will this be a direct bolt on to a JLU Sport or will I have to modify anything? It does not have any backup sensors.
![](/sites/all/themes/quadratec/logo.png)
You will lose any sensors that you currently have and there is no modifications needed for installation on a Sport. Rear corners will match up with Rubicon body lines though, will stick out past the Sport flares